Brain-dumps.com

 
 
 

 
Cisco 
350-001 
350-018 
350-030 
640-025 
640-603 
640-604 
640-605 
640-606 
640-607 
640-801 
640-811 
640-861 
640-901 
640-910 
642-511 
642-521 
642-531 
642-541 
642-641 
642-661 
642-801 
642-811 
642-821 
642-831 
642-871 
642-891 
643-531 
644-101 
646-301 
646-401 
646-521 
9E0-100 
9E0-131 
9E0-422 
9E0-431 
9E0-441 
9E0-541 
9E0-576 
9E0-581 
9E0-601 
9E0-691 
9E0-805 
 
 
Citrix 
1Y0-220 
1Y0-221 
1Y0-610 
1Y0-720 
1Y0-721 
1Y0-910 
1Y0-911 
1Y0-921 
1Y0-931 
1Y0-941 
1Y0-950 
1Y0-951 
1Y0-961 
1Y0-962 
1Y0-991 
 
 
CIW 
1D0-410 
1D0-425 
1D0-450 
1D0-460 
1D0-470 
 
 
Comptia 
220-221 
220-222 
220-231 
220-232 
220-301 
220-302 
225-020 
EKO-001 
IK0-002 
N10-002 
SK0-001 
TK0-001 
XK0-001 
 
 
Microsoft 
70-015 
70-016 
70-019 
70-028 
70-029 
70-080 
70-081 
70-086 
70-088 
70-091 
70-098 
70-100 
70-152 
70-175 
70-176 
70-210 
70-214 
70-215 
70-216 
70-217 
70-218 
70-219 
70-220 
70-221 
70-222 
70-223 
70-224 
70-225 
70-226 
70-227 
70-228 
70-229 
70-230 
70-244 
70-270 
70-284 
70-290 
70-291 
70-292 
70-293 
70-294 
70-296 
70-305 
70-306 
70-310 
70-315 
70-316 
74-100 
ppt2000 
 
 
Novell 
50-632 
50-634 
50-639 
50-640 
50-644 
50-653 
50-654 
50-659 
50-662 
50-676 
50-677 
50-682 
50-683 
 
 
Oracle 
1Z0-001 
1Z0-007 
1Z0-020 
1Z0-023 
1Z0-024 
1Z0-025 
1Z0-026 
1Z0-030 
1Z0-031 
1Z0-032 
1Z0-033 
1Z0-131 
1Z0-132 
1Z0-147 
 
 
Sun 
310-011 
310-012 
310-014 
310-015 
310-025 
310-035 
310-051 
 
 
CWNA 
PWO-100 
 
 
Lotus 
 
 
Compaq 
010-066 
010-067 
 
 
Linux 
117-102 
 
 
IBM 
000-199 
000-285 
000-355 
 
 
DB/2 
000-513 
000-516 
 
 
 
 

Hi, Enjoy all the questions help. 

Questions start here.          

642-801

 

QUESTION 1. Which command would display OSPF parameters such as filters, default metric, maximum paths, and number of areas configured on a router?

A. show ip protocol

B. show ip route

C. show ip ospf interface

D. show ip ospf

Answer: A

QUESTION 2

The following example is a configuration on a 256 kbps HDLC interface: interface serial 0/0bandwidth 56 ip bandwidth-percent eigrp 1 200 Based on this example, how much bandwidth is allocated for EIGRP traffic?

A. 56 kbps

B. 112 kbps

C. 128 kbps

D. 256 kbps

Answer: B

QUESTION 3

Cisco routers perform route summarization automatically for which three routing protocols? (Choose three)

A. IS-IS

B. IGRP

C. OSPF

D. EIGRP

E. RIP v.1

Answer: B, D, E

QUESTION 4

A problem was reported that the 10.10.10.0/24 prefix was not injected into the local BGP table on Router A. The following information is available from RouterA: configuration: router bgp 65001network 10.0.0.0 neighbor 172.16.1.1 remote-as 65002no auto-summary routing table information: show ip route | include 10 O 10.10.0/24 [110/11] via 192.168.1.1, 2d00h, Ethernet0/0 Why is this prefix not in the local BGP table?

A. This route is not a BGP learned route.

B. The network command is wrong.

C. The 172.16.1.1 neighbor is down.

D. The prefix 10.10.10.0/24 is not a connected route.

Answer: A

QUESTION 5

Which command displays RIP routing transactions?

A. show ip rip database

B. show ip route

C. show ip protocols rip

D. debug ip rip

E. debug ip routing

Answer: D

QUESTION 6

In which two types of OSPF networks does a Designated Router (DR) election take place? (Choose two)

A. Point-to-point.

B. Nonbroadcast multi-access

C. Point-to-multipoint

D. Broadcast multi-access

Answer: B, D

QUESTION 7

What are the three general address types of IPv6? (Choose three)

A. Private

B. Unicast

C. Broadcast

D. Public

E. Multicast

F. Anycast

Answer: B, E, F

QUESTION 8

What strategy can a network administrator use to minimize the effect of routing table updates on internal routers when a WAN interface frequently changes its state from up to down?

A. Use a distance vector routing protocol.

B. Use private IP addresses.

C. Use dial-on-demand routing.

D. Use route summarization.

E. Use a routing protocol that tolerates route flapping.

Answer: D

QUESTION 9

What happens if a BGP route reflector receives updates from a peer in another autonomous system?

A. It discards the update.

B. It sends the update to all IBGP peers.

C. It sends the update only to nonclients.

D. It sends the update only to route reflector clients.

E. It sends the update to all routers in the autonomous system.

Answer: D

QUESTION 10

Which IP address is known as the all OSPF DRs and BDRs address?

A. 224.0.0.5

B. 224.0.0.6

C. 224.0.0.9

D. 224.0.0.11

Answer: B

QUESTION 11

In the following BGP configuration, which BGP network statement will inject the 10.10.0.0/16 prefix in the bgp table? interface ethernet 0 ip address 10.10.10.1 255.255.0.0! int serial 0 ip address 172.16.1.1 255.255.255.252! router bgp 65001neighbor 192.168.1.1 remote-as 65002

A. network 10.0.0.0

B. network 10.10.0.0 mask 255.255.0.0

C. network 10.10.10.1 mask 255.255.255.255

D. network 10.10.10.0 mask 255.255.255.0

E. network 10.0.0.0 mask 255.255.0.0

Answer: B

QUESTION 12

What are three characteristics of a Autonomous System (AS) in a BGP network? (Choose three)

A.    Within an AS, all routers must run either BGP or IBGP.

B.    An AS uses exterior gateway protocols (EGPs) to exchange information with other autonomous systems.

C.    An AS is a group of routers under the same technical administration.

D.    Within an AS, routes learned through BGP can be redistributed using interior gateway protocols.

E.     Within an AS, routers learned through an interior protocol cannot be redistributed using BGP to other autonomous systems.

Answer: B C D

QUESTION 13

Which two characteristics areassociated with the distribution layer of the three-layer hierarchical network design model?

A. Reliable transport structure

B. Route redistribution

C. Optimized transport structure

D. Address aggregation

E. Unauthorized entry access control lists

Answer: B, D.

QUESTION 14

Which routing protocol multicasts routing updates using Class D address 224.0.0.9?

A. EIGRP

B. OSPF

C. IGRP

D. RIPv2

Answer: D

QUESTION 15

In OSI terminology, what is a domain?

A. A set of non-routing network nodes.

B. A contiguously connected area that can reach all other areas.

C. Contiguous set of routers and hosts and the data links that connect them.

D. Any portion of an OSI network that is under a common administrative authority.

Answer: D

Braindumps Exam questions Dumps Brain dumps
MCSE Braindumps CCNA Braindumps CCNA Exam Braindump